4X8 TORCHMATE CNC PLASMA 2 TOOL MACHINE WITH PLATE MARK

TM 1 4X8 CNC PLASMA BETTER THEN NEW!! BUILT OUT OF ALL .120 AND 1/4' SUPER HEAVY DUTY. THE GANTRY IS ALL TIG WELDED AND ALSO ADDED A LIENER TO THE CASSETE SLIDE & ALSO MILLED THE STEPPER MOTOR PLATE ON THE GANTRY SO IT'S SPRING LOADED FOR CONSISTANT BACK LASH AND EXTREME ACCURATE.HAS THE DIGITAL HEIGHT CONTROLLER ALONG WITH THE PLATE MARKER.HAVE CABLE CARRIES FOR THE X & Y AXIS. THERE HAS BEEN COUNTLEES MODS DONE TO THIS. IT TOOK ME 4 MONTHS TO BUILD THIS MACHINE TO PERFECTION AND IT SHOW'S!. EVERYTHING ON IT IS NEW AND WAS NO SHORT CUT'S TAKEN. 5' DEEP WATER TABLE THE OVERAL LENGHT OF THIS MACHINE IS 5X9 BUT CUT'S A FULL 4X8 SHEET. IT WILL COME WITH ALL SOFTWARE INCLUDING THE CAD 7.1 EVERYTHING ON THIS MACHINE IS NEW!!! HAS ABOUT 15 MIN IF THAT OF TEST TIME. I HAVE EVERY BIT OF $15K+ INVESTED AND THATS A LOW BALL FIGURE (MINUS PLASMA MACHINE AND COMPUTER!!) AND THAT DOSE NOT INCLUDE MY TIME TO BUILD AND ALL THE MACHINE WORK THAT WENT INTO IT. HAVE THE ORIGINAL RECIPT FROM TM FOR $10K PLUS EVERYTHING ELSE.  I DON'T HAVE THE TIME TO LEARN IT RIGHT NOW. ****************THE MACHINE DOSE NOT COME WITH A PLASMA OR COMPUTER****************** BUT WILL COME COMPLETE WITH EVERYTHING ELSE INCLUDING THE $1000 MACHINE TORCH THAT IS FOR A MILLER 2050.ALSO THE $500 COMPUTER SECURITY CABNET IS INCLUDED.  REALLY TOOOO MUCH TO LIST. EVERY OPITON AND EVEN ALOT THAT DIDN'T EXIST IS ON THIS MACHINE!!! IF YOUR SERIOUS CALL AND WE'LL SET SOMETHING UP FOR U TO COME DOWN AND CHECK IT OUT! NO DISAPOINTMENTS HERE!!!! LOCAL PICK UP ONLY THE MACHINE WEIGHTS 1500LBS +??